S10500這個框式交換機

參考

dis int g 1/0/1

display interface g1/0/X裏麵可以查看接口的最近五分鍾的流量情況

1.1.10  display interface

display interface命令用來顯示接口的運行狀態和相關信息。

【命令】

display interface [ interface-type [ interface-number ] ] [ brief [ description | down ] ]

【視圖】

任意視圖

【缺省用戶角色】

network-admin

network-operator

【參數】

interface-type：指定接口類型。

interface-number：指定接口編號。

brief：顯示接口的概要信息。不指定該參數時，將顯示接口的詳細信息。

description：用來顯示用戶配置的接口的全部描述信息。如果某接口的描述信息超過27個字符，不指定該參數時，隻顯示描述信息中的前27個字符，超出部分不顯示。

down：顯示當前物理狀態為down的接口的信息以及down的原因。不指定該參數時，將不會根據接口物理狀態來過濾顯示信息。

【使用指導】

如果不指定接口類型和接口編號，則顯示所有接口的信息。

如果僅指定接口類型，則顯示所有該類型接口的信息。

【舉例】

# 查看二層以太網接口GigabitEthernet1/0/1的運行狀態和相關信息。

<Sysname> display interface gigabitethernet 1/0/1

GigabitEthernet1/0/1

Current state: DOWN

Line protocol state: DOWN

IP packet frame type: Ethernet II, hardware address: 000c-2963-b767

Description: GigabitEthernet1/0/1 Interface

Bandwidth: 100000 kbps

Loopback is not set

Media type is twisted pair, port hardware type is 1000_BASE_T_AN_SFP

Unknown-speed mode, unknown-duplex mode

Link speed type is autonegotiation, link duplex type is autonegotiation

Flow-control is not enabled

Maximum frame length: 9216

Allow jumbo frame to pass

Broadcast max-ratio: 100%

Multicast max-ratio: 100%

Unicast max-ratio: 100%

PVID: 1

MDI type: Automdix

Port link-type: Access

 Tagged VLANs:   None

 UnTagged VLANs: 1

Port priority: 2

Last link flapping: 6 hours 39 minutes 25 seconds

Last clearing of counters:  14:34:09 Tue 11/01/2011

Current system time:2018-08-10 14:58:27

Last time when physical state changed to up:-

Last time when physical state changed to down:2018-08-10 14:57:58

 Peak input rate: 0 bytes/sec, at 2013-07-17 22:06:19

 Peak output rate: 0 bytes/sec, at 2013-07-17 22:06:19

 Last 300 seconds input:  0 packets/sec 0 bytes/sec -%

 Last 300 seconds output:  0 packets/sec 0 bytes/sec -%

 Input (total):  0 packets, 0 bytes

          0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses

 Input (normal):  0 packets, 0 bytes

          0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses

 Input:  0 input errors, 0 runts, 0 giants, 0 throttles

          0 CRC, 0 frame, 0 overruns, 0 aborts

          0 ignored, 0 parity errors

 Output (total): 0 packets, 0 bytes

          0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses

 Output (normal): 0 packets, 0 bytes

          0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses

 Output: 0 output errors, 0 underruns, 0 buffer failures

          0 aborts, 0 deferred, 0 collisions, 0 late collisions

          0 lost carrier, 0 no carrier

試下這兩條：

dis counters rate inbound interface

dis counters rate outbound interface