SWB:
[SWB]irf member 1 renumber 2 //配置IRF設備成員編號為2,需要確認輸入y
[SWB]save //保存配置,需要確認輸入 y
[SWB]qu
重啟後dis irf 可以看到編號變成了2,相應端口變為2/0/X
SWA:
[SWA]interface range FortyGigE 1/0/53 FortyGigE 1/0/54 //先關閉物理,再配置堆疊口
[SWA-if-range]shutdown
[SWA-if-range]qu
[SWA]irf-port 1/1 //創建堆疊口
[SWA-irf-port1/1]port group interface FortyGigE 1/0/53 //將53接口加入堆疊口
[SWA-irf-port1/1]port group interface FortyGigE 1/0/54 //將54接口加入堆疊口
[SWA]interface range FortyGigE 1/0/53 FortyGigE 1/0/54 //打開53、54接口
[SWA-if-range]undo shutdown
[SWA]sa fo
[SWA]irf-port-configuration active //激活 IRF 配置
SWB:
[SWB]interface range FortyGigE 2/0/53 FortyGigE 2/0/54
[SWB-if-range]shutdown
[SWB]irf-port 2/2 //創建堆疊口
[SWB-irf-port2/2]port group interface FortyGigE 2/0/53 //將53接口加入堆疊口,因設備編號已改為 2 ,端口前麵的數字是 2
[SWB-irf-port2/2]port group interface FortyGigE 2/0/54
[SWB-irf-port2/2]interface range FortyGigE 2/0/53 FortyGigE 2/0/54
[SWB-if-range]undo shutdown
[SWB]save
[SWB]irf-port-configuration active
這樣就可以了,可以做端口聚合,但是你的一款是POE一款是POE 注意一下用途。
我隻需要把poe關了就行吧用不到poe