ensp裏的link-group在HCL是什麼功能

鏈路聚合//www.yolosolive.com/cn/d_201505/868853_30005_0.htm#_Toc419104614

(1)     配置Device A

# 創建VLAN 10，並將端口GigabitEthernet4/0/4加入到該VLAN中。

<DeviceA> system-view

[DeviceA] vlan 10

[DeviceA-vlan10] port GigabitEthernet 4/0/4

[DeviceA-vlan10] quit

# 創建VLAN 20，並將端口GigabitEthernet4/0/5加入到該VLAN中。

[DeviceA] vlan 20

[DeviceA-vlan20] port GigabitEthernet 4/0/5

[DeviceA-vlan20] quit

# 創建二層聚合接口1。

[DeviceA] interface bridge-aggregation 1

[DeviceA-Bridge-Aggregation1] quit

# 分別將端口GigabitEthernet4/0/1至GigabitEthernet4/0/3加入到聚合組1中。

[DeviceA] interface GigabitEthernet 4/0/1

[DeviceA-GigabitEthernet4/0/1] port link-aggregation group 1

[DeviceA-GigabitEthernet4/0/1] quit

[DeviceA] interface GigabitEthernet 4/0/2

[DeviceA-GigabitEthernet4/0/2] port link-aggregation group 1

[DeviceA-GigabitEthernet4/0/2] quit

[DeviceA] interface GigabitEthernet 4/0/3

[DeviceA-GigabitEthernet4/0/3] port link-aggregation group 1

[DeviceA-GigabitEthernet4/0/3] quit

# 配置二層聚合接口1為Trunk端口，並允許VLAN 10和20的報文通過。

[DeviceA] interface bridge-aggregation 1

[DeviceA-Bridge-Aggregation1] port link-type trunk

[DeviceA-Bridge-Aggregation1] port trunk permit vlan 10 20

[DeviceA-Bridge-Aggregation1] quit

collaboration-group

看來學藝不精哈  這個就是鏈路聚合而已